The Fieldpiece Carbon Monoxide Accessory Head measures CO in air and finds CO sources
The Fieldpiece Carbon Monoxide Accessory Head enables most digital multimeters to measure low levels of carbon monoxide in parts per million (PPM). It is intended to measure levels of CO in still ambient air. In many cases, it can pinpoint sources of CO. It uses a catalytic chemical sensor that consumes no chemicals. The most pratical application is to determine if the indoor CO levels are higher than outdooor levels and to determine the source.
Features: Fast enough to locate CO source in “walk-around” test Three pin sensor for better performance Long battery life Auto-off can be disabled for data logging Select averaging or normal for smoothing or fast response to change Rugged mechanical design Standard 9V battery
Spec Summary:
Range:
0 to 1000PPM (2000PPM with 5 minute max exposure time).
Initial accuracy:
0-15ppm ±5% reading ±1 ppm after zeroing; 15-35ppm ±5% reading ±2 ppm after zeroing; 0-1000ppm ±5% reading ±5 ppm after zeroing.
Response time:
<70sec to 90% of reading.
Operating temperature:
32 to 105ºF
Sensor type:
Electrochemical (specific to CO)
Power:
Single standard 9-volt battery
Battery Life:
200 hours
Note: The Fieldpiece Carbon Monoxide Accessory Head is required to be used with the Electronic Handle (EHDL1).
Optional: ACMP3 Pump see specifications for details.
